Discontinued

Doepfer A-127BOM Breakout module for A-127

Item 74 of 247
€ 80,00 (including VAT / BTW)
This item is sold out.

Doepfer A-127BOM Breakout module for A-127

In addition a breakout module A-127BOM is available. This expansion module offers the following additional functions:

  • notch filter for each sub-unit
  • separate outputs for lowpass, highpass, bandpass and notch for each sub-unit
  • separate audio input with attenuator for each sub-unit

The breakout module allows the separate use of each of the three A-127 filters. In addition the filters can be patched parallel or serial. Especially the serial connection of three notches generates very complex phasing-like structures. For parallel filter connection the existing mixer of the main module may be used or an external mixer. For serial connection the filters are patched in the desired sequence at the breakout module. A jumper is used to define the filter type for each sub-unit for the mix unit of the main module. 

Remark: The breakout module can be used without modification only in combination with the new version of the A-127 (pcb printing "Version 4"). Only the new version has the expansion connector available, that is required to connect the breakout module without soldering. It's also possible to combine the breakout module with older versions of the A-127 (versions 1, 2 and 3) but in this case soldering is required to connect the breakout module to the main module (soldering 4 wires to each filter unit). The instructions how to connect A-127BOM and A-127 main module are available here: A127BOM.pdf. This document also describes how to wire older versions of A-127 to the A-127BOM.

 

Width: 28 HP / 141.9 mm
Depth: 55 mm (measured from the rear side of the front panel)
Current: 100mA

Shopping cart

No items in shopping cart.

Newsletter / Nieuwsbrief

Subscribe to our newsletter
Subscribe
© 2013 - 2024 Modularsynthesizers.nl | sitemap | rss | ecommerce software - powered by MyOnlineStore