Doepfer A-100LC6v Low Cost Frame with PSU3 Vintage Edition

€ 370,00 (including 21% VAT)
Stock 5 pcs.
Quantity

Doepfer A-100LC6v Low Cost Frame with PSU3 Vintage Edition (black)

Two rows with 84 HP for installation of modules

Same as the A-100LC6sw case but painted vintage black like the A-100 Minicase black

New: Since spring 2016 the case is also available with black coating :A-100LC6V

Measures:
outside: approx. 445 x 275 x 160 mm
inside: 2 x 84 HP x 3 U (two bus boards), useable depth for A-100 modules: approx. 80 mm in the power supply area (bottom right), resp. approx. 110 mm in the remaining area (measured from inner side of the front panel until end of the pc board of the module)

Weight (without modules): about 4 kg

Maximum Output Current:

with built-in A-100PSU3 (since about early 2016): +12V/2000 mA, -12V/1200mA, +5V/4000mA

In the area near the power supply (bottom right) no modules should be assembled that are sensitive against transformer hum. We recommend to assemble only control voltage modules in this area (e.g. LFO, ADSR, trigger delay, clock divider/sequencer, sequencer, slew limiter, MIDI interfaces and so on) but no audio modules (VCO, VCF, VCA, VCP, frequency shifter, ring modulator, spring reverb and so on). Even modules width increased depth (e.g. A-113 or A-126) cannot be assembled in the power supply area. They have to be placed in a position outside the power supply area (e.g. in the upper row). But this applies only for a few modules. Normally it is no problem to arrange all modules by mounting modules with smaller depth in the power supply area.

Shopping cart

No items in shopping cart.

Sale

Expert Sleepers Disting Mk4 € 195,00 € 189,00

Newsletter

Subscribe to our newsletter
Subscribe

For questions use contactbutton above on the left side

This website uses cookies. Accept More information