Cosmotronic - COSMIX Mk2

Vorige Item 3 of 21 Volgende
€ 319,00 (including VAT)
Stock 2 pcs.

Cosmotronic - COSMIX Mk2

Aural Enhancing Stereo Mixer

Cosmix is an 8-channel stereo mixer with a built in analog stereo dual band maximizer.
It has four mono channels and two stereo channels, the left inputs 5 and 7 are normalised to the right inputs 6 and 8 respectively.
The four mono channels have panning- and aux send controls.
All channels are accommodated with a dedicated mute switch for live performance.

The aux output can be routed to an external effect and the four small switches below the volume faders set whether the signal that is routed to the aux bus is pre or post fader.

The master bus can optionally be fed into the stereo Drive circuit.
This circuit is true stereo, and improves almost any sound source, with full bass and amazing spatial resolution.
It works like a dual band maximizer, with separate faders for high and low frequencies.

The analog overdrive circuit can be bypassed but we don’t recommend it as it sounds great and really glues the whole mix together nicely.
The overall volume can be set with the main volume knob.
The output of the compressor feeds into a diode clipping circuit, to to create a warm saturated distortion.
By playing with the levels of each channel different clipping characteristics can be achieved.
However if you prefer to keep the output signal clean, the bypass switch allows you to bypass the circuit.
The white lines indicate the non-distorted 0dB point for each channel, when the drive circuit is active and the sliders are set to zero.
Driving a channel above the white line pushes it into more overdrive and distortion, assuming 10vpp Eurorack level.
Different tones can be created by playing around with the gain staging!

Main output is eurorack level (10vpp)
Input impedance: 100k
Output impedance: 1k

Manual

  • 60 mA +12V
  • 60 mA -12V
  • 0 mA 5V
  • 20 mm deep
  • 16 HP

COSMIX CAN BE DAISYCHAINED TOGETHER,
TO CREATE LARGER MIXERS.
THE STEREO MIX BEFORE DISTORTION IS SUMMED INTO
THE NEXT MODULE.
THE AUX BUS IS NOT LINKED.
NORMAL OUTPUTS CAN BE USED LIKE REGULAR.
THERE ARE TWO SMALL CONNECTORS ON THE BACK
OF THE MODULE, LABELED INPUT AND OUTPUT.
USE THE SUPPLIED LINK CABLE TO CONNECT
THEM.
PLEASE BE CAREFUL, AS THE CONNECTOR
IS DELICATE, IT IS ADVISED TO USE TWEEZERS
OR A SMALL FLATHEAD SCREWDRIVER TO PUSH
IN THE CABLE.
ONLY CONNECT MODULES WITH POWER TURNED OFF.
THIS FEATURE IS COMPATIBLE WITH COSMIX MK1,
BUT PLEASE MAKE SURE THE RECEIVING MODULE IS
A NEWER MODULE (HAS POWER ON BOTTOM RIGHT)

Shopping cart

No items in shopping cart.

Newsletter

Subscribe to our newsletter
Subscribe
© 2013 - 2021 Modularsynthesizers.nl | sitemap | rss | ecommerce software - powered by MyOnlineStore