Electronics DIY

Cable set for Doepfer CTM64 MIDI Out Kit

This set includes four 16 pin flat cables with 16 pin socket connectors pressed to the cables at one end (length about 50cm) and four 3 pin female connectors with assembled cables for the…

Cable set for the Doepfer DIY-synthesizer.

Two ribbon cables with 16 pins and five with 10 pins, each ~ 50 cm long, with assembled dual row female connectors on one side, the other side of each cable is open, enables to…

A connector set suitable for MTC64

The set includes four 16 pin flat cables with 16 pin socket connectors at one end and one 10 pin flat cable with 10 pin socket connector at one end. The length for all cables is about 50cm.

The CTM Relay Board is an expansion board for the universal MIDI control electronics CTMC64. The reason for this this additional board is the limited cable length between CTM64 main board and the contacts (max. about 50 cm / 2…

CTM64 is an universal MIDI Out kit. Up to 64 free contacts can be connected to generate MIDI note on/off or program change messages. CTM is suitable to retrofit keyboards, switch panels, button arrangements or any other contacts…

Low cost DIY kit to build a full-fledged analog synthesizer. The kit is made of an assembled and tested pc board that includes all that is necessary to build a standard analog synthesizer.

user's manual:…

Driver board with 16 outputs for Doepfer MTC64

The MTC64 outputs are able to drive only very small loads (max. 3 mA) at a very small output voltage (about 4.5 V). Therefore an additional driver for each output is necessary as…

Doepfer MKE is an Universal Midi Keyboard Electronics to built custom-made Midi controllers that include a keyboard. Combining the MKE with our controller electronics Pocket Electronic, Dial Electronic, CTM64 or MTC64 allows the…

MTC64 is an universal MIDI interface that converts up to 64 succeeding MIDI note on/off or program change messages into 64 TTL voltages (0/+5V).

The TTL outputs of the MTC64 can be used to control different switching functions.…

The MTC Relay Board is an expansion board for the universal MIDI control electronics MTC64. It can be used to switch any signal (AC or DC) up to 100V/1A by means of Reed relays (for example audio signals, lamps, motors, magnets,…

Midi-to-Voltage Interface with 16 Analog Voltage Outputs

- interface to convert midi control changes messages (sometimes called simply "midi controllers") to analog voltages- 16 analog voltage outputs 0 ... +5V (0V corresponds to…

Pocket Electronic is an universal electronics DIY kit to built your own MIDI control box. Up to 16 controlling elements can be connected to PE transmitting 16 different MIDI messages on different (or even the same) MIDI…

Universal MIDI Control Electronics with 64 inputs

- 64 inputs, alternatively analog (0...+5V, e.g. generated by rotary or fader potentiometers, same as Pocket Electronic) or digital (e.g. generated by momentary or toggle…

universal Midi Control Electronics especially to connect modulation or pitch wheels, joy sticks, foot controller, breath controller and sustain pedal

Wheel Electronic (abbreviation: "WE" in the following) is an universal…